LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Turn the ignition switch to the OFF position before you remove the instrument panel cluster.
  1. Remove the instrument panel (I/P) cluster trim plate bezel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous) .
    2. Fig 1: View Of Trim Plate Bezel
    GM771732Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the I/P cluster.
  3. Disconnect the electrical connectors from the I/P cluster.
  4. Remove the I/P cluster.
scientia non olet · About LEMON Manuals