LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connectors to the I/P cluster.
  2. Install the I/P cluster.
    3. Fig 1: View Of Trim Plate Bezel
    GM771732Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the I/P cluster.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Install the I/P cluster trim plate bezel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Rendezvous) .
  5. Calibrate the electronic compass. Refer to Electronic Compass Calibration .
scientia non olet · About LEMON Manuals