LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Head Up Display Switch Replacement (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Driver Information Center Switch Electrical Connectors
    GM853292Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors to the switch.
    2. Fig 2: Installed Driver Information Center Switch
    GM853277Courtesy of GENERAL MOTORS CORP.
  2. Install the driver information center switch to the IP trim plate.
  3. Push the switch assembly to the IP trim plate until the assembly is fully seated.
scientia non olet · About LEMON Manuals