LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Head Up Display Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Head Up Display Module
    GM655942Courtesy of GENERAL MOTORS CORP.
  1. Install the heads up display module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that secure the heads up display module to the IP.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  3. Connect the electrical connectors.
  4. Install the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Aztek)  or Trim Pad Replacement - Instrument Panel (I/P) Upper (Rendezvous) .
scientia non olet · About LEMON Manuals