Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Aligning Front Floor Console

Courtesy of GENERAL MOTORS CORP.

Align the front floor console to the floor.
Connect the required electrical connectors.

Fig 2: Locating Front Floor Console Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts to the front of the front floor console.
Tighten: Tighten the nuts to 6 N.m (53 lb in).

Fig 3: View Of Front Floor Console Nuts -Rear

Courtesy of GENERAL MOTORS CORP.

Install the nuts to the rear of the front floor console.
Tighten: Tighten the nuts to 6 N.m (53 lb in).
Install the front floor console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Aztek) or Trim Plate Replacement - Front Floor Console (Rendezvous) .