LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Console Floor >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Instrument Panel (I/P) Upper Bolts
    GM618054Courtesy of GENERAL MOTORS CORP.
  1. Align the front floor console bracket to the floor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the lower nuts (1) to the front floor console bracket.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the upper bolts/screws (2) to the I/P.

    Tighten:  Tighten the bolts/screws to 2.5 N.m (22 lb in).

  4. Install the console electrical center to the original location.
  5. Install the front floor console. Refer to Console Replacement - Front Floor (Aztek)  or Console Replacement - Front Floor (Rendezvous) .
scientia non olet · About LEMON Manuals