LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Diagnostic Information and Procedures >> Chime Always On

Chime Always On

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Chime Always On

Step Action Yes No
Schematic Reference:  Audible Warnings Schematics  
1 Did you perform the Audible Warnings Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Audible Warnings 
2 Are any indicators illuminated? Go to Symptoms - Instrument Panel, Gages and Console  Go to Step 3 
3
  1. Turn OFF the ignition.
  2. Turn the headlamp switch to OFF.
  3. Remove the key from the ignition.
  4. Open the driver's door.
Does the chime sound?
Go to Step 4  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
4
  1. Turn OFF the ignition.
  2. Disconnect the ignition switch connector.
  3. Install a scan tool.
  4. Turn ON the ignition, with the engine OFF.
  5. With a scan tool, observe the Key In Ignition parameter in the Body Control Module data list.
Does the Key In Ignition parameter display Inactive?
Go to Step 6  Go to Step 5 
5 Test the key in ignition input circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
6 Replace the ignition switch. Refer to Ignition Switch Replacement in Steering Wheel and Column.
Did you complete the replacement?
Go to Step 8  -
7
IMPORTANT: Perform the programming procedure for the BCM.
Replace the BCM. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?
Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2