LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Upper Center Pillar >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Upper Center Pillar Trim Panel
    GM620982Courtesy of GENERAL MOTORS CORP.
  1. Align the upper center pillar trim panel to the center pillar.
  2. Install the upper center pillar trim panel by applying pressure at all the retainers locations until fully seated.
  3. Install the lower center pillar trim panel. Refer to Trim Panel Replacement - Lower Center Pillar  .
  4. Install the upper seat belt upper guide loop attachment to the adjuster bracket. Refer to Shoulder Belt Guide Adjuster Replacement - Front in Seat Belts.
scientia non olet · About LEMON Manuals