LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Lower Center Pillar >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lower Center Pillar Trim Panel
    GM620986Courtesy of GENERAL MOTORS CORP.
  1. Install the seat belt to the slot into the center lower trim panel.
    2. Fig 2: View Of Upper Seat Belt Guide Loop Attachment
    GM620984Courtesy of GENERAL MOTORS CORP.
  2. Align the center lower trim panel to the center pillar.
  3. Install the center lower trim panel push-in retainers, applying pressure at all the retainers locations until fully seated.
  4. Install the seat belt escutcheon to the center lower trim panel, applying pressure at all the retainers locations until fully seated.
  5. Install the upper seat belt guide loop attachment to the adjuster bracket. Refer to Seat Belt Retractor Replacement - Right Front (Pontiac) in Seat Belts.
  6. Install the front seat belt to the front seat. Refer to the following procedures in Seat Belts:
  7. Install the front and rear door sill plates. Refer to Door Sill Plate Replacement - Front  and Door Sill Plate Replacement - Rear  .
scientia non olet · About LEMON Manuals