LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Cargo Area Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Access Panel Door
    GM736097Courtesy of GENERAL MOTORS CORP.
  1. Align the panel with the access hole.
  2. Connect the electrical connectors to the panel.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Screw the panel to the cargo side area.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Install the door access panel cover and lock the door with handle.
scientia non olet · About LEMON Manuals