LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Windshield Pillar >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Windshield Garnish Molding
    GM620963Courtesy of GENERAL MOTORS CORP.
  1. Align the windshield garnish molding to the trough on the upper instrument panel trim panel.
  2. Align the windshield garnish molding to the retainers slots in the windshield pillar.
  3. Install the windshield garnish molding, applying pressure at all the retainer locations until fully seated.
scientia non olet · About LEMON Manuals