LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Assist Handle and Rear Coat Hook Replacement (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Expanded View Of Assist Handle and Rear Coat Hook
    GM785495Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors.
  2. Install the bulb socket in the lamp assembly.
  3. Position the pull handle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the assist handle and coat hook.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

scientia non olet · About LEMON Manuals