LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior Trim) >> Repair Instructions >> Assist Handle and Rear Coat Hook Replacement (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Assist Handle Fasteners
    GM548605Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors.
  2. Install the bulb socket in the lamp assembly.
  3. Position the pull handle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fasteners (1).

    Tighten:  Tighten the fasteners to 3 N.m (27 lb in).

scientia non olet · About LEMON Manuals