LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Regulator Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door (Aztek)  or Trim Panel Replacement - Side Front Door (Rendezvous) .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  3. Disconnect the window from the window regulator carrier plate. Refer to Window Replacement - Front Door .
  4. Position the window in the full up position and tape it to the window frame.
    Fig 1: Identifying Window Regulator - Front Door
    GM621584Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the window regulator motor.
  6. Loosen the bolts on the window regulator motor.
  7. Loosen the bolts on the window regulator rail.
  8. Remove the front window regulator, lifting up and out from the key slots on the door inner panel and through the rear access hole.
scientia non olet · About LEMON Manuals