LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Door System, Mirror System & Window System) >> Repair Instructions >> Rubber Conduit Replacement - Rear Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Mark the location and the color of the wires to the electrical socket before removing the wires.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.
  2. Remove the conduit from the center pillar.
  3. Disconnect the rear door wiring harness electrical connector.
    Fig 1: View Of Rear Door Wiring Harness
    GM459522Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the wire harness retainer from the wiring harness socket.
  5. Remove the wiring harness wiring one at a time from the socket.
  6. Remove the rubber conduit from the rear door.
  7. Remove the wiring harness wiring from the rubber conduit.
scientia non olet · About LEMON Manuals