LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Door System, Mirror System & Window System) >> Repair Instructions >> Rubber Conduit Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left or right instrument panel insulator as required. Refer to Closeout/Insulator Panel Replacement - Left or Closeout/Insulator Panel Replacement - Right .
  2. Disconnect the electrical from the front door wiring harness.
  3. Remove the door rubber conduit from where it attaches at the windshield pillar.
    Fig 1: Front Door Rubber Conduit
    GM319803Courtesy of GENERAL MOTORS CORP.
  4. Remove the conduit from the front door.
  5. Remove the front door wiring harness out from the rubber conduit.
scientia non olet · About LEMON Manuals