Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Protect the trim panel at the point of insertion of the flat bladed tool to avoid damaging the door panel.

Use a small flat-bladed tool to remove the mounting plate for the power window switch. Insert the tool at the rear of the mounting plate and release the retainer.

Fig 1: Identifying Rear Door Power Window Switch (Rendezvous)
Courtesy of GENERAL MOTORS CORP.
Lift the rear of the switch plate.

Fig 2: Locating Rear Of Switch Plate (Rendezvous)
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector.

Fig 3: View Of Rear Door Power Window Switch Electrical Connector (Rendezvous)
Courtesy of GENERAL MOTORS CORP.
Remove the power window switch from the mounting plate.