LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Door System, Mirror System & Window System) >> Repair Instructions >> Power Door Lock Switch Replacement (Rendezvous) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Aztek)  or Trim Panel Replacement - Side Front Door (Rendezvous) .
  2. Use a small flat-bladed tool to release the clips at the top and the bottom of the door lock switch.
    Fig 1: View Of Power Door Lock Switch (Rendezvous)
    GM803951Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector from the switch.
  4. Remove the switch.
scientia non olet · About LEMON Manuals