LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Door System, Mirror System & Window System) >> Repair Instructions >> Lock Striker Adjustment - Door >> Mini-Wedge Door Striker Aligner Adjustment Procedure

Mini-Wedge Door Striker Aligner Adjustment Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Properly align the door before adjusting the striker.
  1. Open the door.
  2. Loosen the striker screws just enough to allow the movement of the door striker.
    Fig 1: View Of Lock Striker Components
    GM164537Courtesy of GENERAL MOTORS CORP.
  3. Install J 39346  .
    IMPORTANT: Do not slam the door.
  4. Close the door while holding the outside the handle in the open position.
  5. Open the door.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the striker screws.

    Tighten:  Tighten the striker screws to 24 N.m (18 lb ft).

  7. Remove J 39346  .
  8. Close the door.
scientia non olet · About LEMON Manuals