LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Repair Instructions >> Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Tail Lamp Assembly Screws
    GM621191Courtesy of GENERAL MOTORS CORP.
  1. Open the liftgate.
  2. Remove the screws from the tail lamp.
    3. Fig 2: Identifying Tail Lamp Ball Stud Retainers
    GM621194Courtesy of GENERAL MOTORS CORP.
  3. Pull the tail lamp rearward to disengage it from the ball stud retainers.
    4. Fig 3: View Of Tail Lamp Electrical Connector
    GM621195Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the tail lamp wiring harness.
  5. Remove the tail lamp and backup lamp sockets, depressing the locking tab and rotating counterclockwise.
  6. Remove the side marker lamp socket from the tail lamp by rotating counterclockwise.
  7. Remove the bulbs from the tail lamp, backup lamp and/or side marker lamp sockets.
scientia non olet · About LEMON Manuals