LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of High Mounted Stop Lamp
    GM761263Courtesy of GENERAL MOTORS CORP.
  1. Position the high mounted stop lamp to the roof panel.
  2. Connect the electrical to the high mounted stop lamp.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the high mounted stop lamp screws to the high mounted stop lamp.

    Tighten:  Tighten the high mounted stop lamp screws to 3.5 N.m (31 lb in).

scientia non olet · About LEMON Manuals