LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Repair Instructions >> Headlamp Assembly or Headlamp Bulb Replacement (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Headlamp Retainer
    GM621251Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Halogen Bulb Caution in Cautions and Notices.
  1. Open the hood.
  2. Disconnect the headlamp retainer, by pulling up.
  3. Fig 2: Identifying Headlamp
    GM623855Courtesy of GENERAL MOTORS CORP.
  4. Pull the headlamp from the lower center corner, in order to release the ball studs from the grommet retainers.
  5. Fig 3: Locating Headlamp In Upper Fascia Support
    GM621267Courtesy of GENERAL MOTORS CORP.
  6. Remove the headlamp from the upper fascia support.
  7. Fig 4: Identifying Headlamp Electrical Connector
    GM621268Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical connector from the headlamp.
  9. Remove the headlamp from the vehicle.
  10. Fig 5: Rubber Access Cover At Headlamp
    GM623845Courtesy of GENERAL MOTORS CORP.
  11. Remove the rubber access cover from the headlamp for the bulb you are replacing, if required.
  12. Fig 6: Locating Headlamp Bulb
    GM623839Courtesy of GENERAL MOTORS CORP.
  13. Remove the headlamp bulb from the socket, turning counterclockwise.
  14. Fig 7: Headlamp Bulb Electrical Connector
    GM623948Courtesy of GENERAL MOTORS CORP.
  15. Remove the headlamp bulb from the socket, if required.