LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Lighting Systems) >> Repair Instructions >> Fog Lamp Replacement - Front (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fog Lamp In Front Bumper Fascia
    GM624034Courtesy of GENERAL MOTORS CORP.
  1. Position the fog lamp to the front bumper fascia.
    2. Fig 2: Identifying Fog Lamp Components
    GM761261Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fog lamp nuts (2) to the fog lamp.

    Tighten:  Tighten the fog lamp nuts to 10 N.m (89 lb in).

  3. Connect the fog lamp electrical connector to the fog lamp socket, if removed.
  4. Install the fog lamp socket (3) to the fog lamp by rotating clockwise.
  5. Lower the vehicle.
  6. Check and adjust the fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .
scientia non olet · About LEMON Manuals