LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Starter Motor & Bolts (LY7)
    GM1394040Courtesy of GENERAL MOTORS CORP.
  1. Install the starter motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the starter motor bolts.

    Tighten:  Tighten the starter motor bolts to 50 N.m (37 lb ft).

    3. Fig 2: Identifying Starter Motor BAT Terminal Nut (LY7)
    GM1394041Courtesy of GENERAL MOTORS CORP.
  3. Install the starter motor S terminal electrical connector.
  4. Install the battery positive cable and the BAT terminal nut to the starter motor BAT terminal.

    Tighten:  Tighten the starter motor BAT terminal nut to 13 N.m (115 lb in).

  5. Install radiator air baffle assembly. Refer to Radiator Air Baffle Assemblies and Deflectors in Engine Cooling.
  6. Lower the vehicle.
  7. Install the battery ground (negative) cable to the battery. Refer to Battery Negative Cable Disconnect/Connect Procedure (LA1)  or Battery Negative Cable Disconnect/Connect Procedure (LY7) .
scientia non olet · About LEMON Manuals