Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC clears when the malfunction is no longer present.
- A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.
DTC B0008
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Body Control System Schematics | |||
| 1 | Preform the Diagnostic System Check for the system exhibiting the symptom. Refer to Control Module References . Did you perform the Diagnostic System Check? |
Go to Step 2 | Go to Control Module References |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 |
|
Go to Step 6 | Go to Step 8 |
| 4 | Probe the Park Neutral Position Switch circuit of the BCM with a test lamp that is connected to a good ground. Does the test lamp illuminate? |
Go to Step 5 | Go to Step 6 |
| 5 | Repair the short to voltage in the Park Neutral Position Switch circuit. Did you complete the repair? |
Go to Step 8 | - |
| 6 | Inspect for poor connections at the BCM harness connectors. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 8 | Go to Step 7 |
| 7 |
IMPORTANT:
Perform the set up procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement .Did you complete the replacement? |
Go to Step 8 | - |
| 8 |
|
Go to Step 2 | System OK |