LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 4 Of 4)) >> Repair Instructions (Off-Vehicle - Part 4) >> Exhaust Manifold Installation - Left

Exhaust Manifold Installation - Left

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the exhaust manifold gasket.
  2. Install the exhaust manifold.
    3. Fig 1: View Of Left Exhaust Manifold & Gasket
    GM761236Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the exhaust manifold bolts and nuts.

    Tighten:  Tighten the exhaust manifold bolts and nuts to 38 N.m (28 lb ft) in the proper sequence.

    4. Fig 2: Left Exhaust Manifold Bolt Tightening Sequence
    GM721433Courtesy of GENERAL MOTORS CORP.
  4. Install the exhaust manifold heat shield.
  5. Install the exhaust manifold heat shield bolts.

    Tighten:  Tighten the exhaust manifold heat shield bolts to 8 N.m (71 lb in).

    6. Fig 3: View Of Left Exhaust Manifold Heat Shield
    GM660369Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals