Crankshaft Balancer Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 44643 Flywheel Hold Tool

Lightly lubricate the crankshaft balancer internal hub with engine oil.
Install the crankshaft balancer to the crankshaft.
Lightly lubricate the crankshaft balancer bolt with engine oil.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the crankshaft balancer bolt and washer.
Tighten: Tighten the bolt to 353 N.m (260 lb ft).

Fig 1: View Of Crankshaft Balancer & Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the J 44643 .