LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 4 Of 4)) >> Repair Instructions (Off-Vehicle - Part 4) >> Cooling Fan Pulley Installation

Cooling Fan Pulley Installation

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the camshaft position sensor O-ring with engine oil.
  2. Install the camshaft position sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the camshaft position sensor retaining bolt.

    Tighten:  Tighten the camshaft position sensor retaining bolt to 10 N.m (89 lb in).

    4. Fig 1: View Of Camshaft Position Sensor
    GM660340Courtesy of GENERAL MOTORS CORP.
  4. Install the cooling fan pulley.
  5. Install the cooling fan pulley bolts and nuts.

    Tighten:  Tighten the cooling fan pulley bolts and nuts to 41 N.m (30 lb ft).

    6. Fig 2: View Of Cooling Fan Pulley
    GM660337Courtesy of GENERAL MOTORS CORP.
  6. Connect the camshaft position sensor connector.
scientia non olet · About LEMON Manuals