LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1058 (Engine Mechanical - 6.6L (Lb7) (Repair Instructions 2 Of 4)) >> Repair Instructions (Off-Vehicle - Part 2) >> Engine Flywheel Replacement (Automatic Transmission) >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.
Fig 1: View Of Flywheel Assembly
GM660311Courtesy of GENERAL MOTORS CORP.
  1. Install the flywheel.
  2. Install the flywheel washer.
    NOTE: Refer to COMPONENT FASTENER TIGHTENING NOTICE .
  3. Install NEW flywheel bolts.
    GM660308Courtesy of GENERAL MOTORS CORP.
  4. Install J 44643  in order to hold the flywheel.
    GM663928Courtesy of GENERAL MOTORS CORP.
  5. Using the following steps and the sequence shown, tighten the bolts:

    Tighten 

    Tighten the bolts to 80 N.m (59 lb ft).

    Tighten the bolts to 50 degrees using the J 45059  .

    Tighten the bolt again to 50 degrees using the J 45059  .

  6. Install the transmission. Refer to TRANSMISSION REPLACEMENT (WITH 6.6L ENGINE) , or TRANSMISSION REPLACEMENT (WITH 8.1L (L18) ENGINE) in Automatic Transmission - Allison.
scientia non olet · About LEMON Manuals