LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stud.
    Fig 1: View Of Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
    GM360809Courtesy of GENERAL MOTORS CORP.
  2. Install the 4 washers and the lug nut to the stud.
  3. Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
  4. Remove the lug nut and the washers.
  5. Install the axle shaft for the vehicles with 9.5 in ring gear. Refer toRear Axle Shaft Replacement (8.6 Inch, 9.5 Inch Axles) or Rear Axle Shaft Replacement (9.75 Inch Axle) in Rear Drive Axle.
  6. Install the rear hub assembly for the vehicles with 10.5/11.5 in ring gear, with single wheels. Refer toRear Axle Shaft Replacement (8.6 Inch, 9.5 Inch Axles) or Rear Axle Shaft Replacement (9.75 Inch Axle) in Rear Drive Axle.
  7. Install the rear axle hub for vehicles with dual wheels. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
  8. Install the rotor, except dual wheels. Refer toBrake Rotor Replacement - Rear (Except Dual Wheels or NYS) or Brake Rotor Replacement - Rear (W/Dual Wheels) or Brake Rotor Replacement - Rear (W/NYS) in Disc Brakes.
  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Remove the safety stands.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals