LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (35 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft.
    Fig 1: Installing The Stabilizer Shaft (35 Series)
    GM661064Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft insulator brackets (2) to the rear axle (3).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Installing The Stabilizer Shaft Link To The Frame (35 Series)
    GM661062Courtesy of GENERAL MOTORS CORP.
  3. Install the stabilizer shaft link to the frame (1) and install the retaining bolt (5).

    Tighten: 

    1. Tighten the bolt to frame to 95 N.m (70 lb ft).
    2. Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals