Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the stabilizer shaft link to the frame (1) and to the stabilizer shaft and install the retaining nuts (5).

Fig 1: Installing The Stabilizer Shaft Link To The Frame And To The Stabilizer Shaft (35 Series)
Courtesy of GENERAL MOTORS CORP.

Tighten:
- Tighten the stabilizer shaft link bolt to the frame (1) to 95 N.m (70 lb ft).
- Tighten the stabilizer shaft link to the stabilizer shaft to 50 N.m (37 lb ft).
Lower the vehicle.