LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (15/25 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft link nut and bolt from the frame bracket.
    Fig 1: Removing The Stabilizer Shaft Link Nut And Bolt From The Frame Bracket (15/25 Series)
    GM545533Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link nut from the ball stud.
  4. Remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals