LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (15/25 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft link.
    Fig 1: Installing The Stabilizer Shaft Link (15/25 Series)
    GM545533Courtesy of GENERAL MOTORS CORP.
    2. IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
    Fig 2: Installing The Stabilizer Shaft Link Nut To The Ball Stud (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft link nut to the ball stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 3: Installing The Stabilizer Shaft Link Nut And Bolt To The Frame Bracket (15/25 Series)
    GM545533Courtesy of GENERAL MOTORS CORP.
  3. Install the stabilizer shaft link nut and bolt to the frame bracket.

    Tighten: 

    1. Tighten the link to frame bracket nut to 65 N.m (48 lb ft).
    2. Tighten the ball stud to stabilizer shaft nut to 65 N.m (48 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals