LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft insulator bracket mounting bolts, 15/25 series shown, 35 series similar.
    Fig 1: Removing The Stabilizer Shaft Insulator Bracket Mounting Bolts (15/25 Series Shown; 35 Series Similar)
    GM582397Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft insulators brackets.
  4. Lower the stabilizer shaft and remove the stabilizer shaft insulators.
  5. Inspect all of the parts for wear or damage.
scientia non olet · About LEMON Manuals