LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Place the stabilizer shaft insulators on the stabilizer bar with the slits facing toward the front of the vehicle.
    Fig 1: Installing The Stabilizer Shaft Insulators To The Stabilizer Bar
    GM582397Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer bar.
  2. Install the stabilizer shaft insulator brackets to the rear axle, 15/25 series shown, 35 series similar.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the stabilizer shaft bracket mounting bolts.

    Tighten:  Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals