LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the electrical connector if equipped with Selectable Ride.
  3. Remove the upper shock absorber nut and the bolt.
    Fig 1: Removing The Upper Shock Absorber Nut And The Bolt
    GM348391Courtesy of GENERAL MOTORS CORP.
  4. Remove the lower shock absorber nut and the bolt.
  5. Remove the shock absorber.
scientia non olet · About LEMON Manuals