LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1049 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber.
    Fig 1: Installing The Shock Absorber
    GM348391Courtesy of GENERAL MOTORS CORP.
  2. Install the upper shock absorber nut and bolt.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lower shock absorber nut and bolt.

    Tighten:  Tighten the nuts to 95 N.m (70 lb ft).

  4. Connect the electrical connector if equipped with Selectable Ride.
  5. Remove the safety stands.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals