LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1048 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Tie Rod Replacement - Inner >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  3. Remove the outer tie rod end. Refer to Tie Rod Replacement .
    4. Fig 1: Removing The Inner Tie Rod End
    GM865341Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner tie rod end using theJ 34028  (2).
scientia non olet · About LEMON Manuals