LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1048 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Tie Rod Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the following procedure before installing the new tie rod ends:
  1. Remove all traces of the oil, grease, or other contaminents.
  2. Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE Threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing The Inner Tie Rod To The Relay Rod
    GM865341Courtesy of GENERAL MOTORS CORP.
  4. Install the inner tie rod to the relay rod.

    Tighten:  Using theJ 34028  (2) tighten the tie rod to 100 N.m (74 lb ft).

  5. Install the outer tie rod end. Refer to Tie Rod Replacement .
  6. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.
scientia non olet · About LEMON Manuals