LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1048 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Pitman Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the power steering gear. Refer to Power Steering Gear Replacement (Rack and Pinion) or Power Steering Gear Replacement (Non Rack and Pinion) in Power Steering System.
  3. Install the power steering gear into a vise.
  4. Remove the pitman arm nut and washer.
    5. Fig 1: View Of Pitman Arm, Power Steering Gear, Washer & Nut
    GM398127Courtesy of GENERAL MOTORS CORP.
  5. Remove the pitman arm from the pitman shaft using J 6632-01  or J 29107-A  .
    Fig 2: Removing The Pitman Arm From The Pitman Shaft
    GM398243Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals