LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Engine Mechanical - 6.6L (Lb7) (Introduction)) >> Diagnostic Information and Procedures >> Engine Will Not Crank - Crankshaft Will Not Rotate

Engine Will Not Crank - Crankshaft Will Not Rotate

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Engine Will Not Crank - Crankshaft Will Not Rotate

Cause Correction
Seized accessory drive system component
  1. Remove accessory drive belt(s).
  2. Remove the glow plugs.
  3. Rotate crankshaft by hand at the balancer.
Hydraulically locked cylinder
  • Coolant/antifreeze in cylinder
  • Oil in cylinder
  • Fuel in cylinder
  1. Inspect for fluid at glow plug hole.
  2. Inspect for broken head gasket(s).
  3. Inspect for cracked engine block or cylinder head.
  4. Inspect for a sticking fuel injector.
Seized automatic transmission torque converter
  1. Remove the engine assembly. The torque converter bolts are not accessible with the engine installed to the transmission.
  2. Rotate crankshaft by hand at the balancer or flywheel location.
Seized manual transmission
  1. Disengage the clutch.
  2. Rotate crankshaft by hand at the balancer.
Refer to Unit Repair Manual - Manual Transmission.
Material in cylinder:
  • Broken valve
  • Piston material
  • Foreign material
  • Inspect cylinder for damaged components and/or foreign materials.
  • Repair or replace as required.
Seized crankshaft or connecting rod bearings
  • Inspect crankshaft and connecting rod bearings.
  • Repair as required.
Bent or broken connecting rod
  • Inspect connecting rods.
  • Repair as required.
Broken crankshaft
  • Inspect crankshaft.
  • Repair as required.