LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Engine Mechanical - 6.6L (Lb7) (Introduction)) >> Diagnostic Information and Procedures >> Drive Belt Excessive Wear Diagnosis >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Excessive wear on a drive belt is usually caused by incorrect installation or the incorrect drive belt for the application.

Minor misalignment of the accessory drive belt pulley(s) will not cause excessive wear, but will probably cause the drive belt to make a noise or fall off.

Excessive misalignment of the accessory drive belt pulley(s) will cause excessive wear and may also make the drive belt fall off.

scientia non olet · About LEMON Manuals