LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Engine Mechanical - 6.6L (Lb7) (Introduction)) >> Diagnostic Information and Procedures >> Coolant in Engine Oil

Coolant in Engine Oil

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Coolant in Engine Oil

Cause Correction
DEFINITION: Foamy or discolored oil or an engine oil "overfill" condition may indicate coolant entering the engine crankcase. Low coolant levels, an inoperative cooling fan, or a faulty thermostat may lead to an "overtemperature" condition which may cause engine component damage. Contaminated engine oil and oil filter should be changed.
  1. Inspect the oil for excessive foaming or an overfill condition. Oil diluted by coolant may not properly lubricate the crankshaft bearings and may lead to component damage. Refer to Lower Engine Noise, Regardless of Engine Speed .
  2. Inspect by performing a Cylinder Leak-Down Test. During this test, excessive air bubbles within the cooling system may indicate a faulty gasket or damaged component.
  3. Inspect by performing a cylinder compression test. Two cylinders "side-by-side" on the engine block with low compression may indicate a failed cylinder head gasket. Refer to Engine Compression Test .
Faulty cylinder head gasket Replace the head gasket and components as required. Refer to Cylinder Head Cleaning and Inspection and Cylinder Head Replacement - Left or Cylinder Head Replacement - Right .
Warped cylinder head Replace the cylinder head gasket. Refer to Cylinder Head Replacement - Left or Cylinder Head Replacement - Right .
Cracked cylinder head Replace the cylinder head and gasket.
Cracked cylinder liner or engine block Replace the components as required.
Cylinder head, block, or manifold porosity Replace the components as required.
Leaking engine oil cooler Replace components as required.
Damaged injector tube or O-Ring Replace components as required.
Faulty water pump Replace components as required.