LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1041 (Front Suspension System) >> Repair Instructions >> Wheel Hub, Bearing, and Seal Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
  2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
    3. Fig 1: Identifying Brake/Hub Components
    GM379487Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring (7) to the steering knuckle, 25/35 series.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the wheel speed sensor mounting bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

  5. Install the wheel hub and bearing and splash shield to the vehicle, 25/35 series.
    6. Fig 2: Installing The Wheel Hub And Bearing (RWD, 15-Series)
    GM379486Courtesy of GENERAL MOTORS CORP.
  6. Install the wheel hub and bearing (4) and splash shield to the 15-series steering knuckle.
  7. Install the wheel hub and the 15-series bearing mounting bolts.

    Install the wheel hub and bearing mounting bolts, the 25/35 series.

    Tighten:  Tighten the bolts to 180 N.m (133 lb ft).

  8. Install the wheel speed sensor and brake hose mounting bracket bolt to the steering knuckle.

    Tighten:  Tighten the brake hose clip bolt to 12 N.m (106 lb in).

  9. Install the rotor. Refer to Brake Rotor Replacement - Front .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals