LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1041 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement (Coil Spring Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ball joint to the lower control arm.
  2. Install the replacement bolts to the lower control arm.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the nuts to the bolts.

    Tighten:  Tighten the nuts to 70 N.m (52 lb ft).

  4. Remove the lower control arm from the bench vice.
  5. Install the lower control arm. Refer to Lower Control Arm Replacement (RWD)  or Lower Control Arm Replacement (4WD) .
  6. Install the tire and wheel tire assembly. Refer toTire and Wheel Removal and Installation in Tires and Wheels.
  7. Remove the safety stands.
  8. Lower the vehicle.
  9. Verify the wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
scientia non olet · About LEMON Manuals