LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft and/or Gasket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flange bolts.
    2. Fig 1: Axle Flange Bolts
    GM665974Courtesy of GENERAL MOTORS CORP.
  2. Lightly tap the axle shaft with a soft-faced hammer in order to loosen the shaft.
  3. Grip the rib on the axle shaft flange with a locking pliers. Twist the axle shaft flange in order to start the axle shaft removal.
  4. Remove the axle shaft from the tube.
  5. Remove the gasket.
  6. Clean the axle shaft flange and the outside face of the hub assembly.
scientia non olet · About LEMON Manuals