LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the drive bar extension onto the drive bar of J 33049  .
  2. Insert the J 33049  into the opposite side axle shaft tube.
  3. Install the J 45177  onto the J 33049  .
  4. Insert the axle shaft seal into the axle tube.
    5. Fig 1: Axle Tube
    GM820550Courtesy of GENERAL MOTORS CORP.
  5. Install the J 45177  (1) and the J 33049  (2) over the axle shaft seal.
    6. Fig 2: J 45177 & J 33049
    GM815639Courtesy of GENERAL MOTORS CORP.
  6. Drive the axle shaft seal into the axle tube using the J 45177  , the J 33049  and a hammer.
  7. Install the differential assembly. Refer to Differential Replacement (8.6 Inch, 9.5 Inch Axles) , Differential Replacement (9.75 Inch Axle)  or Differential Replacement (10.5 Inch, 11.5 Inch Axle) .
  8. Install the axle shafts. Refer to Rear Axle Shaft Replacement (8.6 Inch, 9.5 Inch Axles)  or Rear Axle Shaft Replacement (9.75 Inch Axle) .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals