LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Replacement (9.75 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the rear steering gear assembly. Refer to Steering Gear Actuator and Cover Replacement in Rear Wheel Steering.
  5. Remove the steering knuckle assembly. Refer to Steering Knuckle Replacement in Rear Wheel Steering.
  6. Remove the lock clip from the axle shaft end. The lock clip is spring loaded and fits securely in the axle shaft slot and may need to be push off the shaft end with a screw driver or related tool. Pushing the axle shaft inwards towards the gears my help in removal of the lock clip.
    7. Fig 1: Removing Lock Clip From Axle Shaft End
    GM791718Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When removing the axle shaft do not rotate the shaft. Rotating the shaft will cause the gears to move. Misalignment of the gears will make the assembly difficult.
  7. Remove the axle shaft.
    8. Fig 2: Axle Shaft
    GM791714Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals