LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Replacement (9.75 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the axle shaft.
    2. Fig 1: Axle Shaft
    GM791714Courtesy of GENERAL MOTORS CORP.
  2. Install the spring loaded lock clip to the axle shaft end.
    3. Fig 2: Installing Lock Clip From Axle Shaft End
    GM791718Courtesy of GENERAL MOTORS CORP.
  3. Install the steering knuckle assembly. Refer to Steering Knuckle Replacement in Rear Wheel Steering.
  4. Install the rear steering gear assembly. Refer to Steering Gear Actuator and Cover Replacement in Rear Wheel Steering.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals